iglidur® L250, ležaj sa prirubnicom, mm - L250FM

Za velike brzine

iglidur® L250, ležaj sa prirubnicom, mm - L250FM
iglidur® L250, ležaj sa prirubnicom, mm - L250FM drawing
1 iz 2
iglidur® L250, ležaj sa prirubnicom, mm - L250FM
iglidur® L250, ležaj sa prirubnicom, mm - L250FM drawing
igus-icon-lupe
igus-three-dimensional-model
  • Broj dela: L250FM-0608-06
  • Materijal: iglidur® L250
  • Oblik: Flanširani ležajevi
  • Dimenzije:
    • d1 6 mm
    • d2 8 mm
    • d3 12 mm
    • b1 6 mm
    • b2 1 mm
  • Više iglidur® L250 delova
  • Metod proizvodnje: Injekciono oblikovanje
  • Radni vek:
Svojstva materijala:
  • Izvrsni koeficijenti trenja
  • Otpornost na ivice pritiska
  • Otporan na udarce i padove
iglidur® L250 | For high speeds
iglidur® L250 is a plain bearing material for high speeds, fast sliding movements and low coefficient of friction. The iglidur® L250 material can highlight these advantages particularly with low loads. Applications featuring these advantages are fans, small motors, fast-running sensors or the magnet technology.

Typical application areas

Automotive

Here you will find further possible applications:
Industry solutions
 
When to use it?
  • For rotating applications at high speed
  • When the highest service life is required
  • For low load applications
  • When a low noise level is required
  • For very low coefficient of friction
When not to use it?
Use our filter options to find the suitable product

Tolerances and measuring system
The installation dimensions and tolerances of the iglidur® bearings depend on the material and wall thickness. Moisture absorption and thermal expansion are decisive for the material. Plain bearings with low moisture absorption can be designed with a minimal amount of bearing clearance. The following applies to the wall thickness: The thicker the bearings, the greater the bearing clearance must be.
Test procedure

Installation
iglidur® bearings are press-fit bearings. The inner diameter is only adjusted to the appropriate tolerance after pressing into the housing bore. The press-fit interference can be up to 2% of the inside diameter. This ensures the secure press-fitting of the bearing. Axial or radial displacements in the housing are thus reliably avoided.
iglidur® - installation, bonding, machining
 
Niste sigurni da li odgovara?